Visara 1486 - Manual (Page 102)

701334-002 B-3
System Configuration
Configuring a Locally Attached Printer
To manually configure a local printer attached to a 1486A/G/P, use the CRTDEVPRT
command with the following parameters:
CRTDEVDSP
DEVD(display-station-name)
DEVCLS(*LCL)
TYPE(xy)¹
MODEL(Fz)²
LOCADR(local-address)
CTL(work-station-controller)
¹For a 4214 printer, set the MODEL to 2.
For a 5219 printer, set the MODEL to D2.
For a 5256 printer, set the MODEL to 2.
²z = 4214, 5219, or 5256.
Configuring a Remotely Attached Printer
You must configure a remotely attached printer manually.
To configure a printer attached to a 1486A/G/P that is remotely attached to either a 5394
or a 5294 Remote Controller, use the CRTDEVPRT command with the following
parameters:
CRTDEVDSP
DEVD(display-station-name)
DEVCLS(*RMT)
TYPE(xy)¹
MODEL(Fz)²
LOCADR(local-address)
CTL(work-station-controller)
¹For a 4214 printer, set the MODEL to 2.
For a 5219 printer, set the MODEL to D2.
For a 5256 printer, set the MODEL to 2.
²z = 4214, 5219, or 5256.