Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 52)

3-22 W A N s u i t e 5 2 6 0 / 5 2 3 0
Idle Pattern Selects the DS0 idle pattern sent by the unit and lets the unit determine if the
DS0 idle pattern has been sent by the other end.
Values: 0
−
255
Default: 127
Figure 3.17 DS0 Monitor 24 Hour History Screen
Figure 3.18 DS0 Monitor 30 Day History Screen
The DS0 Monitor 24 Hour History and 30 Day History screens show the
following statistics for the specified period.
Period Period for which the DS0 monitor history is displayed.
Timestamp System-up-time value during which the utilization historical period was
completed.
% Utilization of DS0(s) Percent of DS0s utilized (
−
1, 0
−
100) over the period. A
−
1 indicates an
invalid value or unavailable data.
High Utilization (sec) Number of seconds (0
−
900) greater than or equal to the high utilization
parameter specified for the period in the utilization alarm table.
Two user-activated buttons, “Clear History” and “Refresh,” are also included
on the 24 Hour and 30 Day History screens.
Frame Relay Service Details Screen
Click on “Frame Relay” under the “Type” column on the Services screen to
access the Frame Relay Service Details screen (Figure 3.19). This screen lets
you access the configuration parameters described in the paragraphs below.