Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 215)

F r o n t P a n e l L C D I n t e r f a c e 5-19
LL The Local Loopback (LL) parameter can be set to “Enable” or “Disable.”
Selecting “Enable” allows the unit to go into LL when the LL pin on the
Serial port goes high. The unit exits the loop when the LL pin goes low. If
you select “Disable,” the unit ignores the LL pin on the Serial port.
Values: Disable, Enable
Default:Disable
For more information on pin assignments, refer to Connector Pin Assignments
on page A-7.
DTR Control Lets you set the Data Terminal Ready (DTR) alarm control parameters.
Choices for DTR Alarm Control are “Enable” and “Disable.” Setting DTR
Alarm Control to “Enable” allows the unit to go into alarm on a loss of DTR.
Values: Disable, Enable
Default:Disable
Supervisory Configuration Menu
Use the SUPV CONFIG menu to set up parameter values for the Supervisory
port as shown in Figure 5.17 and defined in the paragraphs below.
Figure 5.17 Supervisory Configuration Menu
Speed Changes the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Ch Size Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Stop Bits Selects the number of bits required to end the asynchronous character.
Values: 1, 2
Default: 1
Parity Sets the parity bit.
Values: None, Odd, Even
Default: None
DTR Alarm Sets the DTR Alarm.
Values: Enable, Disable
Default: Disable
Supv
Config
Speed Parity Stop Bits
1200, 2400,
4800,9600,
19200, 38400,
57600, 115200
None
Odd
Even
1
2
DTR Alarm
Dis
En
Diag Msgs
Dis
En
Five
Six
Seven
Eight
Ch Size