Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 135)

V T 1 0 0 I n t e r f a c e 4-19
Figure 4.14 Service Table Screen
The Service Table screen displays the available services listed by Index
number. From this screen, you can navigate to a Service Details screen
(Figure 4.15) from the column, to an Interface Details screen from
the column, or to a Type Details screen from the column.
To add a service, select the “Add Service” prompt at the top of the screen.
Figure 4.15 Service Details Screen
From this screen, you can access and change the parameters listed below. The
new parameters are saved when you press the “Esc” key and return to the
previous screen.
Interface Selecting one of the interfaces will bring up a screen where you can view
interface parameters. These screens are the same ones displayed when you
select a sub-menu from the Interfaces screen described earlier on page 4-6.
NOTICE: One of the Interface options is “Virtual.” PPP is the only service that may
be attached to the Virtual interface. You would choose the Virtual interface for
PPP if you elected to run PPP over Frame Relay. When you attach PPP to the