Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 115)

W e b S e r v e r I n t e r f a c e 3-85
Figure 3.78 Frame Relay Network
If the remote units are required to have an IP address for Networks that are
different from the remote routers, a static route will have to be configured in
the local router (Router A) for each remote WANsuite 5260/5230 to manage.
If Router A becomes unavailable, there is no way to reach the remote
WANsuite 5260/5230s.
Use of Local WANsuite 5260/5230 as a Gateway
If you choose this method, the WANsuite 5260/5230s are totally independent
from the routers, so all units will be accessible as long as the frame relay
network stays up. The IP address assignment is also independent from the
routers. The PC used for management must have the local WANsuite 5260/
5230’s IP address as its gateway address so that it can reach all remote
WANsuite 5260/5230s.
Figure 3.79 Frame Relay Network
In the local WANsuite 5260/5230, the IP address and mask of each remote
WANsuite 5260/5230 will have to be configured in the Endpoint table. The
“In-Band Management” parameter will also have to be set in the
corresponding DLCI. Each remote WANsuite 5260/5230 must be part of a
different IP network address.
PC
Router
A
FSM
FSM
FSM
Router
C
Router
B
WAN SUITE
5260/5230
WAN SUITE
WAN SUITE
5260/5230
5260/5230
PC
Router
A
FSM
FSM
FSM
Router
C
Router
B
WAN SUITE
WAN SUITE
WAN SUITE
5260/5230
5260/5230
5260/5230