Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 208)

5-12 W A N s u i t e 5 2 6 0 / 5 2 3 0
Configuration Menu
The Configuration menu lets you configure the parameters of the various
interfaces.
Figure 5.11 WANsuite 5260 Configuration Menu Tree
Figure 5.12 WANsuite 5230 Configuration Menu Tree
TCP/IP Configuration Menu
The TCP/IP CONFIG menu lets you configure the unit’s IP parameters. Use
the
SCROLL button to display the desired configuration parameter, and then
press the SELECT button to activate the configuration function.
Figure 5.13 TCP/IP Configuration Menu Tree
IP Address
This menu lets assign a unique network address to this unit.
To establish an IP Address, press the SELECT button to activate a blinking
cursor over the first digit’s location (an “x”) in the address to indicate that the
value is selected for change. Press the
SCROLL button to incrementally
change the selected digit’s value (0–9). When the desired value for a selected
portion of the address is displayed, press the
SELECT button to set that value
and to move to the next value in the address. Pressing the SELECT button
while the blinking cursor is on the last digit enters the value and returns to the
previous screen. Pressing the
EXIT button at any time while entering an IP
address aborts the edit.
TCP/IP Config
Configuration
Net 2 Config Serial 2 Config Net 1 Config Serial 1 Config Supv Config
Configuration
Serial Config Net Config TCP/IP Config
TCP/IP Config
Subnet Mask
xxx.xxx.xxx.xx
IP Address
xxx.xxx.xxx.xx
Gateway Address
xxx.xxx.xxx.xx
DHCP Client
Dis
En