Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 154)

4-38 W A N s u i t e 5 2 6 0 / 5 2 3 0
changed Name parameter will cause the endpoint entry and its corresponding
DLCI entry to be saved in the configuration database.
Value: A string of up to 11 characters
Default: None
CAUTION: When configuring endpoints, the name you assign each endpoint in
the Name parameter field must be unique within the unit.
Service The Service Index number (from the Service Table) on which this DLCI was
found or configured.
Values: Displays the currently active Services (by index number) or the
Service(s) on which the DLCI was discovered.
Default: 0
DLCI The DLCI number.
Values: 16–1023
Default: 0
Forward Endpoint By default, each DLCI is switched to its pair service in the Service Table
using the same DLCI number. If this endpoint has to be switched to a
different DLCI or a different service, the endpoint index of the destination
must be configured here.
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0
Backup Endpoint If this DLCI has an alternate endpoint to switch to in case this DLCI becomes
inactive, you would configure the endpoint index of this alternate endpoint
here.
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0
SLP Reference
Endpoint
Use this reference endpoint index for the SLA parameters. As most
applications have the same SLAs for all DLCIs, they only need to be
configured in one DLCI entry. You can then copy all SLA parameters from
the endpoint index of this configured DLCI. If no SLP reference endpoint is
configured and the DLCI SLA parameters are not configured, the values in
the Frame Relay Service Details will be used (default CIR, Be, enforcement).
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0
Remote IP Address If this WANsuite 5260/5230 unit is to be used to manage a remote
WANsuite 5260/5230 unit, you must configure the IP address of the remote