Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 188)

4-72 W A N s u i t e 5 2 6 0 / 5 2 3 0
Figure 4.64 Static TCP Translation Details Screen
NAT Ports Screen
The parameters on the NAT Ports screen (Figure 4.65) define the NAT global/
Internet and local/Corporate ports. These parameters are configured in the
NAT Ports Details screen shown in Figure 4.66. Access the NAT Ports Details
screen by selecting the number of the desired port on the NAT Ports
screen.
Figure 4.65 NAT Ports Screen
Enable Enables or disables the NAT port. Default is “Enable.”
Default Translation Forces translation on a specific IP port regardless of the source IP Address. If
Default Translation is set to “Enable,” the packet will never be discarded, but
will always pass through the translation path. Therefore, any packets with a
destination address different from the global/Internet network address will be
processed by the IP Gateway, and may be routed to another port. If this
parameter is set to “Disable,” no packet with a destination address different
from the global/Internet address will be processed. Setting this parameter to