Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 136)

4-20 W A N s u i t e 5 2 6 0 / 5 2 3 0
Virtual interface, you must supply an endpoint over which to send PPP
encapsulated data, and that endpoint must be for a Frame Relay DLCI.
Type Selecting one of the services listed under the “Type” column will bring up a
screen where you can view (and, in some cases, change) parameters for each
type of service. The details displayed depend on the type of service currently
in effect. These screens are shown and described below according to each
type of service.
Pair User-assigned integer field that specifies where to route the traffic from this
service. If the service is terminated by the unit, set this value to “0” (zero).
Delete Service Select the “Delete Service” prompt to remove the currently configured service
identified by the Service Details screen. Deleting the selected service will
remove all references to this service.
After selecting “Delete Service,” you will be presented with a confirmation
screen similar to the one shown in Figure 4.5. Select “Yes” to confirm
removal of the selected service.
DS0 Monitor Details Screen
To access the DS0 Monitor Details Screen (Figure 4.16), click on “TDM” in
the column on the Service Table screen. This screen lets you
configure what are considered high and low DS0 utilization parameters, and
will report alarms if the monitored statistics rise above or fall below those
specified settings. This helps determine customer load patterns so that channel
bandwidth can be reallocated as necessary.
Figure 4.16 DS0 Monitor Details Screen
Number of DS0s Number of active DS0s (0
−
24) assigned on a per-service basis.