Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 172)

4-56 W A N s u i t e 5 2 6 0 / 5 2 3 0
RIP Trust Neighbors Globally enables the trusted neighbors feature. If there is a list of trusted
neighbors in an IP Gateway, only RIP packets coming from those trusted
neighbors will be used to build the internal routing table.
Values: Enable, Disable
Default: Enable
RIP Interval Interval for RIP packet to be sent. Default is 30 seconds.
RIP Domain Value representing the RIP domain. Default is 0.
OSPF Parameters
OSPF Enable OSPF stands for Open Shortest Path First Routing, which is a shortest-path-
first (SPF) or link-state protocol. OSPF is an interior gateway protocol that
distributes routing information between routers in a single autonomous
system. This Protocol is suitable for complex networks with a large number of
routers. If a large network is involved, OSPF may be the solution for the user.
Values: Disable, Enable
Default: Disable
OSPF Router ID This 32-bit number assigned to each router running the OSPF protocol
uniquely identifies the router within an Autonomous System. Each router
requires a unique router ID. Default is the LAN IP address of the unit.
The IP Gateway screen provides the following user prompts that may be
selected by pressing the “Enter” key:
Circuit Table Screen
This menu shows the configured circuit. To configure a new circuit, select
"Add New."
Prompt Function
RIP Parameters
Static Route Table Displays static and dynamic route information.
Static ARP Table Displays static ARP information.
Trusted Neighbors Displays trusted neighbors information.
OSPF Parameters
Area Table Displays area information.
Virtual Link Table Displays virtual link information.
Circuit Table Provides user access to circuit-related information/
operation.