Teac SS-CDR200 - Manual (Page 27)

TASCAM SS-CDR200/SS-R200/SS-R100
27
NOTE
The screen above is an example from an SS-CDR200.
SS-R200 and SS-R100 models do not have the
CD
menu.
2 Press the DEVICE button (or remote control DEVICE
SELECT button) to select the device to use, and
press the MULTI JOG dial (or remote control ENTER
button) to confirm.
NOTE
You can also turn the MULTI JOG dial to select the device.
3 The name of the selected device appears at the
bottom right of the Home Screen.
Device name
USB
: Select USB memory
SD
: Select SD card
CF
: Select CF card
CD
: Select CD with commercial audio CD (SS-CDR200
only)
CDR
: Select CD with CD-R (SS-CDR200 only)
CDRW
: Select CD with CD-RW (SS-CDR200 only)
Preparing USB/SD/CF media for use
You must format USB/SD/CF media with this unit in order
to make them usable by the unit.
CAUTION
• Formatting will erase all data on the USB/SD/CF media.
• Always format with this unit. If USB/SD/CF media is
formatted by another device or a computer, it could
affect operation of the unit.
1 Press the DEVICE button (or remote control DEVICE
SELECT button) to open the
DEVICE SELECT
screen, and select the device with the media that
you want to format. (See “Selecting the device
used” on page 26.)
2 Press the MENU [JOG] button (or remote control
MENU button) to open the
MENU
screen.
3 Open the
UTILITY
menu.
4 Select
MEMORY FORMAT
.
5 Press the MULTI JOG dial (or remote control ENTER
button).
A confirmation pop-up message appears.
6 Press the MULTI JOG dial (or remote control ENTER
button) again to start formatting.
During formatting,
--FORMAT--
and a progress bar
is displayed in a pop-up.
7 After formatting completes, the pop-up disappears
and the
UTILITY
menu reopens.
8 Press the HOME/DISPLAY button (or remote control
HOME/DISP button) to return to the Home Screen.
Panel lock function
While pressing and holding the SHIFT button, press the
,
[LOCK] button to turn the panel lock function, which
disables operation of the front panel buttons, ON and OFF.
When panel lock is ON, using any front panel buttons
(except the SHIFT and , [LOCK] buttons) or remote
control buttons will cause a
--Key Lock--
and
ON
pop-up to appear.
NOTE
Even when panel lock is ON, control is still possible when
using a TASCAM RC-3F footswitch connected to the front
panel REMOTE JACK or an external device connected to
one of the rear panel RS-232C, PARALLEL or REMOTE IN
(RC-SS2) CONTROL I/O connectors.
3 − Preparations