Teac SS-CDR200 - Manual (Page 26)

26
TASCAM SS-CDR200/SS-R200/SS-R100
3 Pull the SD or CF card out the rest of the way.
Using the security screw
The included security screw can be used to lock the card
slot door.
Use a Phillips screwdriver to install or remove the security
screw.
SD card write protection
SD cards have write-protection switches.
Unprotected Protected
If the protection switch is slid into the “LOCK” position,
adding and editing files will not be possible. To record,
erase or otherwise change files, disable write protection.
NOTE
When using a protected SD card, every time the device
is changed, the audio files on the card will be checked
beforehand. For this reason, changing devices takes time.
Moreover, editing the playlist and other operations are
not possible.
Inserting and removing discs
(SS-CDR200 only)
Inserting discs
With the disc label up, insert it partway into the disc slot.
Push the disc in a little further and it will be pulled in
automatically just before it disappears into the slot.
After the disc is inserted, the unit reads the disc
information. The total number of tracks and total playback
time of an audio CD will be shown. The total number of
tracks in the current folder of a data CD will be shown.
CAUTION
• Discs cannot be inserted when the power is OFF.
• Trying to force a disc in could damage the unit. If a disc
becomes stuck partway, for example, and is difficult to
push, do not try to force it in. Pull it out once, press the
EJECT button and then try inserting it again.
• MEDIA ERROR
will appear if discs other than audio CDs
are inserted or discs are inserted upside-down. Press
the EJECT button to eject such a disc.
• When inserting 3-inch CDs, be sure to insert them in
the middle of the slot completely.
NOTE
You can insert a disc anytime the power is ON, regardless
of the current device setting.
Ejecting discs
Press the EJECT button to eject a disc partially. Holding it
by its sides, pull it out the rest of the way.
CAUTION
When the power is off, the EJECT button does not
function.
Selecting the device used
Before using the unit, select the device (USB, SD, CF or CD)
for the type of media that you are using (choose CD for
CD-R and CD-RW discs).
To select the device used, follow these procedures.
1 Press the DEVICE button (or remote control DEVICE
SELECT button) to open the
DEVICE SELECT
screen.
3 − Preparations