Teac SS-CDR200 - Manual (Page 11)

TASCAM SS-CDR200/SS-R200/SS-R100
11
• To clean the signal side of a disc, wipe gently with a soft
dry cloth from the center towards the outside edge.
Dirt on discs can lower the sound quality, so clean
them and always store them in a clean state.
• Do not use any record spray, anti-static solutions,
benzene, paint thinner or other chemical agents to
clean CDs as they could damage the delicate playing
surface. It may cause CDs to become unplayable.
• Do not apply labels or other materials to discs. Do
not use discs that have had tape, stickers or other
materials applied to their surface. Do not use discs that
have sticky residue from stickers, etc. Such discs could
become stuck in the unit or cause it to malfunction.
• Never use a commercially available CD stabilizer. Using
stabilizers with this player will damage the mechanism
and cause it to malfunction.
• Do not use cracked discs.
• Only use circular compact discs. Avoid using
non-circular promotional, etc. discs.
• Music discs with copy control, a copy-protection
system, have been released from several record
companies in an attempt to protect the copyright.
Since some of these discs do not comply with the CD
specifications, they may not be playable on the unit.
• If you are in any doubt as to the care and handling of a
CD-R and CD-RW discs, read the precautions supplied
with the disc, or contact the disc manufacturer directly.
About CD-R and CD-RW discs
CD-R discs can be recorded once only. Once they have
been used for recording, they cannot be erased or
re-recorded. However, if space is available on the disc,
additional material can be recorded.
By finalizing a CD-R that you have finished using for
recording, you can make it playable by most ordinary CD
players. (Some CD players might not be able to play back
CD-R discs even if they are finalized.)
CD-RW discs allow recorded tracks to be erased to make
space available again, allowing disc reuse. However, tracks
can only be erased in the order from the last added. To
erase a track in the middle, you must erase all the tracks
added after it at the same time. Finalized CD-RW discs can
only be played back in CD players that support CD-RW
disc playback.
Slot loading of discs
1 As shown in the illustration, hold the disc with the
labeled side up and insert it part way into the slot.
2 After you push the disc a little further, it will be
pulled in automatically just before it disappears
into the slot.
Loading 3-inch CDs
When loading a 3-inch CD, push it into the center of the
slot completely. If not centered, loading might not occur
properly.
Trouble inserting a disc
If the disc becomes stuck during insertion, for example,
and is difficult to push, do not try to force the disc in. Pull
the disc out once and press the EJECT button and then
try inserting it again. (Trying to force the disc in could
damage the unit.)
1 − Introduction