Teac SX-1 Quick Start Guide - Manual (Page 27)

Chapter 6 –Taking Control
TASCAM SX-1 Quick Start Guide
27
MIDI
A MIDI REC MODE
This section accesses the
SX-1's Step mode and MIDI Merge function. Just
beneath the
MIDI REC MODE
section is a
PANIC
but-
ton for resetting stuck MIDI devices. See the
Owner's Manual for more information about MIDI
Recording.
NOTE
The PANIC key is a latching-type key. Press once to
enable panic mode (the indicator pulses) and again to
disable panic mode.
Editing
B EDITING
For all your audio waveform and
MIDI note editing needs, there is the
EDITING
sec-
tion. Here you will find basic cut, copy, and paste
commands, as well as many other advanced editing
commands (such as, ripple, crop, and split). To learn
more about the SX-1's extensive audio waveform and
MIDI editing capabilities, see the Owner's Manual.
Transport and Data Entry
C TRANSPORT
Though this area is not actually
labeled
Transport
on the SX-1, that title best
describes this section of the SX-1's face. Here you
will find a set of standard transport keys (play, stop,
record, fast forward, rewind, end jump, and begin-
ning jump). Just above the transport keys are controls
for capturing and recalling locate points.
The SX-1 has many advanced transport functions
(including looping, user definable post/pre roll times,
and auto punch). As well, the Jog/Shuttle wheel is
handy for jogging, scrubbing, and shuttling. To learn
more about these advanced features, see the Owner's
Manual.
D DATA ENTRY The numeric keypad is labeled
DATA ENTRY
. Keys on the numeric keypad are used
for entering numbers (and letters) directly into
onscreen fields, enabling shifted functions and spe-
cial key commands (see “Multi-Function Keys” on
page 9), up/down and left/right cursor navigation,
and entering MIDI step record note values (see the
Owner's Manual for more on the
DATA ENTRY
section).