Scotsman C2648 - Manual (Page 8)

C2648 Prodigy and Prodigy Plus Service Manual
January 2015
Page 8
Panel Removal
1. Locate and loosen the two screws at the bottom
edge of the front panel.
2. Pull the front panel out at the bottom until it clears
the bin.
3. Lower the front panel down and off the machine.
4. Remove two screws from the front corners of the
top panel.
5. Lift up the front of the top panel, push it back an
inch, then lift to remove.
6. Locate and remove the screws holding each side
panel to the base.
7. Pull the side panel forward to release it from the
back panel.
This manual covers several models. The model
number on the ice machine can be found either on
the dataplate, which is on the back panel, or the serial
number tag, which is behind the front panel. See the
illustration for the locations of the dataplate and the
serial number tag.
The remote condenser has a separate model and
serial number. Its model and serial number is on the
dataplate on the condenser near the quick connect
fittings.
Write the model and serial number of the ice machine
here:
Write the model and serial number of the remote
condenser here:
Write the model and serial number of the ice storage
bin here:
Write the day of initial start up here: That day starts
the warranty period.
Uncrate and Set Up
Begin with the ice storage bin. Uncrate and attach
legs. Check the bin top gasket for tears or gaps. If
recycling an older bin, replace the gasket or repair
with food grade sealant prior to placing the ice
machine on the bin.
Install the bin top adapter if one is required for the
application.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. Cut away any
shipping strapping. Lift the ice machine off the skid
directly onto the bin.
Note: The machine is heavy. Use a mechanical lift.
If lifting from the front, be sure that fork tines are
under the front and back of the cabinet. If lifting
from the side, be sure to have tines under the
front and back. Do not lift on the sump bottom.
Scotsman BH1100, BH1300, BH1600: Position back
of ice machine about 2 3/8” from back of bin.
Secure the ice machine to the bin with the hardware
provided (two metal Z straps and four bolts).