Denon AVR-4306 - Manual (Page 93)

88
Advanced Setup – Part 2 Advanced Setup – Part 2
Check the parameter
• The results of the measured items can be checked.
• The EQ parameters that were set in Auto Setup can be
checked.
• This item is displayed, after the measurement result of the
“Auto Setup / Room EQ” is decided.
1 Press the CURSOR D D or H H button to select
“Parameter Check” at the “Auto Setup / Room
EQ” menu, then press the
ENTER button.
• The “Parameter Check” screen appears.
4 Press the CURSOR D D or H H button to select the
Equalizer curve, then press the ENTER button.
• The “EQ Check” screen appears.
2 Press the CURSOR D D or H H button to select the
items, then press the ENTER button.
• The verification screen appears.
For instructions on checking the results of each item (
page 12, 13).
3 Press the CURSOR D D or H H button to select “EQ
Parameter Check”, then press the ENTER
button.
• The “EQ Parameter Check” screen appears.
The display is only an approximate picture of the response
and that correction is happening at all frequencies.
5 Press the CURSOR F F or G G button to select the
speaker channel.
6 If the check ends, pressing the CURSOR D D or H H
button to select “Exit”, then press the ENTER
button.
• The “EQ Parameter Check” screen reappears.
7 Press the CURSOR D D or H H button to select
“Exit”, then press the ENTER button.
• The “Parameter Check” screen reappears.
8 The results of the “Auto Setup” procedure can
be reset even if the settings have been changed
after performing the “Auto Setup” procedure:
Press the
CURSOR D D or H H button to select
“Restore Yes 0 0”, then press the CURSOR F F
button.
9 Press the CURSOR D D or H H button to select
“Exit”, then press the ENTER button.
• The “Auto Setup / Room EQ” menu reappears.