Denon AVR-4306 - Manual (Page 28)

23
Connecting Other Sources Connecting Other Sources
• When the surround back’s power amplifier is assigned to the ZONE2 or ZONE3 output channel
at “Power Amp Assign” in the “System Setup Menu”, the surround back speaker terminals can
be used as the ZONE2 or ZONE3 speaker out terminals (
page 61).
• The connections diagram below is an example for when the surround back speaker is assigned
to the ZONE2 stereo 2 channel.
In this case, surround back speaker out can not be used for MAIN ZONE.
ZONE2 / ZONE3 speaker out connections
ZONE2
• Use these terminals if you wish to connect external power amplifier(s) to increase the power of
the front, center, surround and surround back sound channels, or for connection to powered
loudspeakers.
• When using only one surround back speaker, connect it to the left channel.
Connecting the pre-out terminals
Power amplifier
R
SURROUND
BACK
L
R
SURROUND
L
R
FRONT
L
CENTER
SUB-
WOOFER
R
L
R
L
B
A
B
A
R
L
R
L
R
L
R
L
A
Connecting the power supply cord
AC 120 V, 60 Hz
AC outlets
(wall)
Power supply cord
(Supplied)
NOTE:
• Only use the AC OUTLETS for audio
equipment. Never use it for hair driers, TVs
or other electrical appliances.
• Insert the plugs securely. Incomplete
connections will result in the generation of
noise.
AC OUTLETS
• SWITCHED (total capacity – 120 W (1 A.))
The power to the outlet is turned on and
off in conjunction with the POWER switch
on the main unit, and when the power is
switched between on and standby from
the remote control unit.
No power is supplied from this outlet
when this unit’s power is at standby. Never
connect equipment whose total power
consumption exceeds 120 W (1 A.).
> < > <
> < > < > < > < > <
> < > <
IN
(R) (L) (L) (R)
(L) (R) (L) (R)
Connection
terminal for
subwoofer
with built-in
amplifier
(subwoofer),
etc.
Surround speaker
systems (B)
Front speaker
systems
Surround speaker
systems (A) Subwoofer
ZONE2 Front speaker
systems
Center speaker