Denon AVR-4306 - Manual (Page 82)

77
Advanced Setup – Part 1 Advanced Setup – Part 1
Setting the Volume Control
Set the upper limit for the volume, the volume level when the
power is turned on, and the volume level when the mute mode
is set for the different zones.
1 Press the CURSOR D D or H H button to select
“Volume Control” at the “Option Setup” menu,
then press the
ENTER button.
• The “Volume Control” screen appears.
2 Press the CURSOR D D or H H button to select the
desired setting, then press the CURSOR F F or G G
button to select the parameter.
Volume Limit:
Set the upper limit for the volume for the different zones.
• –20 dB, –10 dB, 0 dB:
The volume cannot be increased above the selected levels.
• OFF:
If you do not want to set a volume limit, select “OFF”.
In this case, the volume can be set to the AVR-4306’s
maximum volume (output) level of +18 dB, which is
extremely loud.
Mute Level:
Set the volume attenuation level when the mute mode is set
for the different zones.
• FULL
The volume is fully muted.
• –40 dB
The volume is lowered 40 dB from the current level.
• –20 dB
The volume is lowered 20 dB from the current level.
Volume Level:
Set whether to fix the output level for the different zones or
make it variable.
• Variable
The level can be adjusted freely using buttons on the remote
control unit.
• –40 dB, 0 dB
The output level is fixed at the set level and the volume can
no longer be adjusted.
3
Press the ENTER button to enter the setting.
• The “Option Setup” menu reappears.
• For ZONE2 and ZONE3, the “Volume Limit” and “Power On
Level” can be set when “Variable” is selected for “Volume
Level”.
• When the power amplifier is assigned to either of the ZONE2
and ZONE3 channels at “Power Amp Assign”, “–VAR–” (only
variable) is displayed and the fixed level cannot be set.
Setting the Trigger Out
1 Press the CURSOR D D or H H button to select
“Trigger Out” at the “Option Setup” menu, then
press the
ENTER button.
• The “Trigger Out” screen appears.
3 Press the CURSOR F F or G G button to select the
zone (MAIN ZONE, ZONE2 and ZONE3).
The power supplied from the trigger out terminal turns on
and off when the power for the set zone is turned on and
off.
2 Press the CURSOR D D or H H button to select the
trigger out terminal you want to set, then press
the
ENTER button.
• The setting screen appears.
Example: When “Trigger Out 1” is selected
• Two 12 V DC Trigger Outputs on the rear panel can be used to
control other devices with compatible trigger inputs, such as
motorized screens, motorized screen masking, motorized
drapes, and other trigger-controlled devices.
• Set the DC output supplied from the trigger out terminals for
the various input sources to “ON” or “OFF”.
Power On Level:
Set the volume that is set when the power is turned on for
the different zones.
You can adjust the MAIN ZONE volume level within the range
of –80 dB to +18 dB and ZONE2 (or ZONE3) volume level
within the range of –70 dB to +18 dB in steps of 1.0 dB.
• – – – (Mute)
The volume is always muted when the power is turned on.
• LAST
The volume set when the AVR-4306 was last used is stored
in the memory and set when the power is turned on.
“Aux1” is setting of “AUX/Net”, and “Aux2” is setting of
“AUX/iPod”.