Denon AVR-4306 User Manual

Page 26

Connection of AM antennas

Connecting Other Sources

AM loop antenna assembly

Connect to the AM

antenna terminals.

Remove the vinyl tie
and take out the
connection line.

Bend in the reverse
direction.

a. With the antenna

on top any stable
surface.

b. With the antenna

attached to a wall.

Mount

Installation hole Mount on wall, etc.

NOTE:
• Do not connect two FM antennas

simultaneously.

• Even if an external AM antenna is used, do

not disconnect the AM loop antenna.

• Make sure the AM loop antenna lead

terminals do not touch metal parts of the
panel.

An F-type FM antenna cable plug can be connected directly.

Connecting the antenna terminals

Note to CATV system installer:
This reminder is provided to call the CATV
system installer’s attention to Article 820-40
of the NEC which provides guidelines for
proper grounding and, in particular, specifies
that the cable ground shall be connected to
the grounding system of the building, as
close to the point of cable entry as practical.

Direction of broadcasting station

Ω

/ohms

Coaxial cable

FM antenna

FM indoor antenna

(Supplied)

AM loop antenna

(Supplied)

AM outdoor antenna

GROUND

Connecting the XM terminal

• AVR-4306 is the XM Ready® receiver. You can receive XM Satellite Radio® by connecting to the

XM Connect-and-Play

(sold separately) and subscribing the XM service.

• Plug the XM Connect-and-Play antenna into XM terminal on the rear panel.
• Position the XM Connect-and-Play antenna near a south-facing window to receive the best signal.

For details, see “XM Satellite Radio” (

page 42).

When making connections, also refer to the operating instructions of the XM Connect-and-Play
antenna.

NOTE:
• Keep the power supply cord unplugged until the XM Connect-and-Play antenna connection

have been completed.

XM Connect-and

-Play Antenna

1. Push the

lever.

2. Insert the

conductor.

3. Return the

lever.