Denon AVR-4306 - Manual (Page 92)

87
Advanced Setup – Part 2 Advanced Setup – Part 2
Others Setup
Setting the Room EQ Setup
Select the setting of an Equalizer that has been set with Auto
Setup or Manual EQ.
1 Press the CURSOR D D or H H button to select
“Room EQ Setup” at the “Auto Setup / Room
EQ” menu, then press the
ENTER button.
• The “Room EQ Setup” screen appears.
2 Press the CURSOR F F or G G button to select “All”
or “Assign”.
All:
Sets the Equalizer for all surround modes.
Assign:
Sets the Equalizer individually for each surround mode.
Setting the Direct Mode Setup
Perform the ON/OFF setting of Room EQ when the surround
mode is “DIRECT” or “PURE DIRECT”.
1 Press the CURSOR D D or H H button to select
“Direct Mode Setup” at the “Auto Setup / Room
EQ” menu, then press the
ENTER button.
• The “Direct Mode Setup” screen appears.
2 Press the CURSOR F F or G G button to select “ON”
or “OFF”.
3
-1
When “All” is selected:
q
q Press the ENTER button.
• The “Room EQ” screen appears.
3
-2
w w Press the CURSOR F F or G G button to select the
equalizer setting.
OFF:
The Equalizer is not used.
Audyssey:
Adjusts the frequency response of all speakers to correct the
effects of room acoustics.
Front:
Adjusts the frequency response of the surround speakers to
match the characteristics of the front channel speakers.
Flat:
Adjusts the frequency response of all speakers to the flattest
response. This mode is suitable for multi-channel music
surround sound sources.
Manual:
Selects the setting value that was set in the Manual EQ
Setup.
For details of the “Manual EQ Setup” (
page 75, 76).
When “Assign” is selected:
After completing system setup, select the desired
equalizer setting pressing the
ROOM EQ button.
• Equalizer settings for the individual surround modes can
be stored in the memory.
Whenever the ROOM EQ button is pressed, the display
switches as shown below.
OFF Audyssey
Flat Manual
Front
4
Press the ENTER button to enter the setting.
• The “Auto Setup / Room EQ” menu reappears.
3
Press the ENTER button to enter the setting.
• The “Auto Setup / Room EQ” menu reappears.
• The Equalizer setting of “Audyssey”, “Front” and “Flat” can be
selected after performing the Auto Setup.
• When the speaker set as “None” with the Auto Setup is
changed to on manually, the equalizer of “Audyssey”, “Front”
and “Flat” cannot be used.
• The Equalizer setting can be selected directly by ROOM EQ
button.
• When headphones are connected, the Room EQ cannot be
used.
Setting the MIC Input Select
Sets whether the setup microphone is connected to the PIN
JACK (V.AUX L channel) connector or the MINI JACK (SETUP
MIC) connector.
1 Press the CURSOR D D or H H button to select “Mic
Input Select” at the “Auto Setup / Room EQ”
menu, then press the
ENTER button.
• The “Mic Input Select” screen appears.
2 Press the CURSOR F F or G G button to select “Mic”
or “V.Aux L”.
3
Press the ENTER button to enter the setting.
• The “Auto Setup / Room EQ” menu reappears.