Denon AVR-4306 User Manual

Page 69

Advanced Operation

Switch off the unit using the main unit’s

POWER

switch.

Hold the following

ROOM EQ

button and

NIGHT

button, and turn the main unit’s

POWER

switch

on.

• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the settings are reset

to the default values (the values set upon shipment from the
factory).

Last function memory

• This unit is equipped with a last function memory which stores

the input and output setting conditions as they were
immediately before the power is switched off.
This function eliminates the need to perform complicated
resetting when the power is switched on.

• The unit is also equipped with a back-up memory. This function

provides approximately one week of memory storage from
when the main unit’s power switch is off and with the power
supply cord disconnected.

Initialization of the microprocessor

• In very rare instances, the AVR-4306 internal microprocessor

might lock up, or otherwise cause mis-operation. This might be
caused due to an AC line surge or line spike noise, or by static
electric discharge on or nearby the unit, or to connected
components. If the condition cannot be corrected by powering
off the unit, including disconnection of the power supply cord
for a period of ten minutes and subsequent re-connection, then
the unit may have to be re-initialized. Doing so will restore the
microprocessor to its original out-of-the-box state, with all
custom memories and settings erased, and the original factory
default settings restored. Only use this procedure if you are
sure that the microprocessor requires re-initialization.

Check that the entire display is flashing with an
interval of about 1 second, and release your
fingers from the 2 buttons.

• The microprocessor will be initialized.

Multi-source recording / playback

Playing one source while recording another
(REC OUT mode)

Press the

ZONE2/3/REC SELECT

button until

“ZONE2 SOURCE” appears on the display.

With “ZONE2 SOURCE” displayed, turn the

FUNCTION

knob until “RECOUT SOURCE”

appears on the display.

• The REC indicator lights.

With “RECOUT SOURCE” displayed, turn the

FUNCTION

knob to select the source you wish to

record.

Set the recording mode.

For operating instructions, refer to the manual of the
component on which you want to record.

R E C O U T S O U R C E

D V D

• To cancel, turn the FUNCTION knob and select “SOURCE”.
• Recording sources other than digital inputs selected in the REC

OUT mode are also output from the ZONE2 preout terminals.

• If and only if the digital signal being input from the digital input

terminal (optical/coaxial) is a PCM signal, it is output from the
analog REC OUT terminals.

• When “DENON LINK” is assigned at “Digital In Assign”, it is

not possible to output the PCM signal and Network Audio
signals (Internet radio music server, USB) being input from the
digital audio input terminal from the analog REC OUT terminals
(

page 67).

• When the REC OUT mode is selected, the ZONE2 button on the

remote control unit cannot be operated.

• Network Audio (Internet radio, music server or USB) signals are

not output from the OPTICAL 3 OUT and OPTICAL 4 OUT
terminals.

The function switches as shown below when the FUNCTION
knob is turned.

ZONE2 SOURCE

ZONE2 TUNER

····

ZONE2 V.AUX

RECOUT SOURCE

RECOUT VCR-2

RECOUT V.AUX