Denon AVR-4306 User Manual

Page 89

Advanced Setup – Part 2

Press the

CURSORF

button to set the

distance between the center speaker and
listening position.

Example: When the distance is set to 10 feet for the

center speaker

The distance changes in units of 1 foot (0.1 meters) or 0.1
foot (0.01 meters) each time the button is pressed. Select
the value closest to the measured distance.
When “Step” is selected, you can select the unit of “1 ft
(0.1 m)” or “0.1 ft (0.01 m)”.
When “Yes” is selected for “Default”, the settings are
automatically reset to the default values.
Please note that the difference of distance for every
speaker should be 20 ft (6.0 m) or less. If you set an
invalid distance, a CAUTION notice, such as screen right
will appear. In this case, please relocate the blinking
speaker(s) so that its distance is no larger than the value
shown in highlighted line.

The “Surr. Sp.” can only be selected when both surround
speakers A and B have been selected at the System Setup
Menu (when both A and B have been set to “Large” or
“Small”).

When the surround back speaker setting is set to “1spkr”
for “Speaker Configuration”, this is set to “SB”.

Press the

ENTER

button to enter the setting.

• The “Speaker Setup” menu reappears.

• Use this setting to adjust so that the playback level between

the different channels is equal.

• From the listening position, listen to the test tones produced

from the speakers to adjust the level.

Press the

CURSOR D

button to select

“Channel Level” at the “Speaker Setup” menu,
then press the

ENTER

button.

• The “Channel Level” screen appears.

Press the

CURSOR D

button to select “Test

Tone Start”, then press the

CURSOR F

button to

select “Yes”.

Press the

CURSOR F

button to select

“Auto” or “Manual”.

-1

When “Auto” mode is selected:
Press the

CURSOR F

button to adjust all

the speakers to the same volume.

• The test tones are emitted from each speaker in the

following order, at 4-second intervals during the first and
second time, and at the 2-second intervals during the
third and subsequent cycles:

Auto:

Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.

Manual:

Select the speaker from which you want to produce the test
tone to adjust the level.

Surr. Sp. : A

Adjusts the balance of the playback level between the
channels when using surround speaker A.

Surr. Sp. : A + B

Adjusts the balance of the playback level between the
channels when using surround speakers A and B at the same
time.

Surr. Sp. : B

Adjusts the balance of the playback level between the
channels when using surround speaker B.

Press the

CURSOR D

button to select “Surr.

Sp.”, then press the

CURSOR F

button to

select the surround speaker(s) from which you
want to produce the test tone (A, B or A+B).

Example: When the “Auto” mode is selected

1spkr

2spkrs

SBL

SBR

Setting the Channel Level

The AVR-4306 automatically sets the optimum surround
delay time for the listening room.