Denon AVR-4306 - Manual (Page 76)

71
Advanced Setup – Part 1 Advanced Setup – Part 1
3 Press the CURSOR D D or H H button to select the
input source, then press the CURSOR F F or G G
button to select the input terminal.
Select from among HDMI1 to 3.
If the same HDMI input terminal is selected, the setting for
the input source that was previously assigned switches to
“NONE”.
Make the video-related settings.
Video Setup
Setting the HDMI In Assignment
• This setting assigns the HDMI input terminals for different
input sources.
• Set the method for playing the audio signals included in the
HDMI input signal.
1 Press the CURSOR D D or H H button to select
“Video Setup” at the “System Setup Menu”,
then press the
ENTER button.
• The “Video Setup” menu screen appears.
4 Press the CURSOR D D or H H button to select the
method for playing the audio signals included in
the HDMI input signal, then press the
CURSOR
F F or G G button to select “AMP” or “TV”.
5 Press the CURSOR D D or H H button to select the
input for the playback of signals when the audio
signal of HDMI can not be reproduced, then
press the
CURSOR F F or G G button to select the
input signal (ANALOG or EXT. IN).
2 Press the CURSOR D D or H H button to select
“HDMI In Assign”, then press the ENTER
button.
• The “HDMI In Assign” screen appears.
TV:
Play the audio signals on a TV connected to the AVR-4306.
AMP:
Play the audio signals on speakers connected to the AVR-
4306.
When the audio signal of HDMI has become unlocked, the
unit automatically changes over to the set connector
(ANALOG or EXT. IN).
1~3 correspond to each HDMI 1~3 input terminal.
6
Press the ENTER button to enter the setting.
• The “Video Setup” menu reappears.
• If a monitor is connected with an HDMI cable but the monitor
is not compatible with HDMI audio signal playback, only the
video signals are output to the monitor from the AVR-4306 (DVI
mode).
Press the STATUS button to check which mode is set for
outputting HDMI signals from the AVR-4306 (HDMI and DVI
modes).
• Audio signals input from the analog and digital terminals are not
output to the TV.
• With HDMI, the video and audio signals are transferred
simultaneously. When HDMI is assigned to an input source, the
digital audio input assignment switches to HDMI along with the
video input.
When this setting is made for input sources to which a digital
audio input (DENON LINK, OPTICAL etc.) is previously
assigned, the digital audio assignment is set to HDMI.
In this case, reassign the digital input using the procedure
described at “Digital In Assign” (
page 67) .
• It is not possible to make the “HDMI In Assign” settings for the
function assigned at “iPod Assign”.
Setting the Component In Assignment
This setting assigns the component video input terminal of the
AVR-4306 for the different input sources.
1 Press the CURSOR D D or H H button to select
“Component In Assign” at the “Video Setup”
menu, then press the
ENTER button.
• The “Component In Assign” screen appears.