Denon AVR-4306 User Manual

Page 49

Basic Operation

Playing the iPod

iPod

Connecting the iPod

Music stored on an iPod can be played when the iPod is connected to the AVR-4306’s iPod connector. The iPod can be controlled
using the buttons on the main unit and the remote control unit.

With the iPod, non-copyrighted contents and contents that may be legally reproduced or played may be reproduced and played by
individuals for their personal use. Violating copyrights is prohibited by law.

iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.

• Connect the iPod cable (sold separately) directly to the iPod.

(To connect via an iPod Dock, see “Setting the iPod Assign”
(

page 68)).

• Some of the functions may not operate, depending on the type

of iPod and the software version.

Connect the AVR-4306 and iPod using the iPod
cable.

(Main unit)

(Remote control unit in the AMP mode)

If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.

Select the input source to “AUX/iPod”.

• The iPod music menu screen is displayed.

A r t i s t s

P l a y l i s t s

Display

(iPod screen)

NOTE:
• The AVR-4306 is equipped with two iPod connectors, one

each on the front and rear panels. It is not possible to use
the set with iPods connected to both the connectors at the
same time. Only connect one iPod at a time.

• DENON will accept no responsibility whatsoever for loss or

damage of data on an iPod occurring when the iPod is used
connected to the AVR-4306.

• The maximum battery charge output from the iPod

connector is 8 W.

iPod