Rena T-950 - Manual (Page 59)

SETUP & OPERATION
53
7. If the screen to the right is displayed,
press the Operate soft key to toggle from
the “pass-thru” mode to the “operate”
mode.
8. Press the RUN key, on the control panel,
to start the tabber.
The tabber will begin to run and the
screen will display the Rate in pieces per
hour and number of Pieces run.
9. To stop the Tabber, press the Red STOP key next to the Run key on the Control Panel.
Current Job #: 2, # of Tabs is 2 (All)
Rate: 0 Piece/Hour, Pieces: 0
Status: Ready to tab. Press STOP to exit
Press RUN for pass-thru mode.
Status: Pieces: 0
Mode Tab Jog Operate Advanced