Rena T-950 - Manual (Page 38)

SETUP & OPERATION
32
If the Offset soft key is pressed.
The display will prompt you to set the Offset
value (starting position from leading edge) for
each tab/stamp.
Offset Value = distance from leading edge of
mail piece to leading edge of tab.
 Tab 1 – Use this soft key to set the offset value
for tab/stamp 1.
 Tab 2 – Use this soft key to set the offset value
for tab/stamp 3.
 Tab 3 – Use this soft key to set the offset value
for tab/stamp 3.

EXIT – Brings you back to the previous
screen.
If the Tab 1 soft key is selected then you will be asked to enter the offset value for Tab 1.
In the following example, # Tabs was set to 3.
Note: The number of tab choices, you are presented
with, is based off the “# Tabs” and the “tab
placement” (separate, together), that you previously
selected. If “# Tabs” was set to 1 or tab placement
“together” was selected; you will be prompted to
“Enter tab offset 1…” as soon you press the Offset
key.
Enter the desired offset value for Tab #, using the
numeric keypad, then press the SAVE button.
Press EXIT.
Repeat this process for each tab/stamp position.
Press EXIT to return to the option screen.
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
# Tabs Offset Backing EXIT
Select tab offset to edit
Status: Job Setup
Tab 1 Tab 2 Tab 3 EXIT
Select tab offset to edit
Status: Job Setup
Tab 1 Tab 2 Tab 3 EXIT
Enter tab offset 1 and press SAVE key:
0.0”
Current Value: 4.000”
Status: Job Setup
EXIT