Rena T-950 - Manual (Page 41)

SETUP & OPERATION
35
If the Tab, Stamp Fwd, or Stamp Rev soft keys
are pressed.
The display will prompt you to select
number of Tabs/stamps, set Length of media and
set Backing type.
 # Tabs - This soft key is used to select the
number of tabs you plan to place on the
media.

Length - This soft key is used to set the
media length.
 Backing - This soft key is used to set the type
of tab/liner material that is being used, and
the Pitch of the tab.
 EXIT – Brings you back to the screen shown
at top of page.
If the # Tabs soft key is pressed.
The display will prompt you to select the
number of tabs/stamps you would like applied to
each mail piece.
 1 – Selects one tab/stamp
 2 – Selects two tabs/stamps
 3 – Selects three tabs/stamps

EXIT – Brings you back to the previous
screen.
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
# Tabs Length Backing EXIT
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
Tab Stamp Fwd Stamp Rev EXIT
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
# Tabs Offset Backing EXIT
Press 1, 2 or 3 for the number of tabs.
Current Value: 2
Status: Job Setup Pieces: 0
1 2 3 EXIT