Rena T-950 - Manual (Page 40)

SETUP & OPERATION
34
Automatic Tab/Stamp Positioning Features (Auto Pos.)
When the Auto Pos. soft key is pressed.
The display will prompt you to select the Job
number you wish to use or edit.
When a Job #, soft key is pressed.
The display will prompt you to “Select option to
edit or Press RUN to tab using Job #”.
In our example, we are selecting Job # 2 using
the soft key 2.
 Tab – This soft key is used to place tabs
onto the media.
 Stamp Fwd - This soft key is used to place
stamps at the trailing edge of the media.
 Stamp Rev - This soft key is used to place
stamps at the leading edge of the media.
 EXIT – Brings you back to the “Select
program mode Job# or Automatic”
screen/selections (shown at top of page).
Select program mode Job# or Automatic.
Status: Mode
Job# Auto Pos. EXIT
Select Saved Job # (1-4), or
Press RUN to tab using Job 1
Status: Job #
1 2 3 4
Select Saved Job# (1-4), or
Press RUN to tab using Job 1
Status: Job #
1 2 3 4
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
Tab Stamp Fwd Stamp Rev EXIT