Rena T-950 - Manual (Page 34)

SETUP & OPERATION
28
3
4
Media Thickness Adjustment
1. Close the exit cover [1] and lock it into position using the two locking levers [2].
2. Using the Media Thickness Adjustment [3]
crank, raise the exit rollers until you can easily
pass a single piece of media [4] between the exit
rollers.
3. Insert one piece of media [4]
into the exit end of the tabber
(just under the exit rollers).
Adjust the Media Thickness
Adjustment [3] crank to lower
the upper exit rollers, until
you begin to feel a little drag
on the media. Continue
turning one full crank rotation
further, so there is sufficient
pressure on the piece of
media to drive it through the
system.
1
2