Rena T-950 - Manual (Page 26)

SETUP & OPERATION
20
Loading Roll Labels
Labels supplied in roll form, such a Post-it notes and packaging labels, can be treated as you
would when loading tabs/stamps. See “Loading Tabs/Stamps” on previous page.
Loading Fan-Folded Labels less than 2” Long
The Fan Folded Label tray has to be installed in order to run fan-folded labels on the tabber.
The steps required are below:
1. Remove any labels or tabs that may be installed
on the machine.
2. Remove the 2” Tab/Label applicator head and
replace it with the 4” Label applicator head.
3. Remove the Roll Guide [1] and the Roll Core
Support [2] from the machine. The roll core
support is held in place by an Allen screw.
4. Install the Label Tray over the spindle as
shown.
5. Use the two thumbscrews [3] to attach the
tray assembly to the Tab Reel holder.
Tip: When applying labels with perforated backing, the perforations must be strong enough to
withstand the force it takes to advance and peel a label. If the perforations are not strong enough
the label backing (web) will break. This type of stock will not perform correctly with this system.