Rena T-950 - Manual (Page 54)

SETUP & OPERATION
48
10. In this example, the tab stock is translucent, with
a black block below each tab and a white line
(space) between each tab. This is considered an
“Opaque” liner type. Press the Opaque soft key.
11. Press the Backing soft key again.
12. Press the Pitch soft key.
13. Enter the Tab Pitch using the numerical keypad.
In this example, the tab stock is a 15/16” round
tab with a 1/16” space between tabs, so the pitch
(measured from top of tab to top of next tab) is
1”. For the machine to work properly, you must
set the pitch for 0.010” larger than this
measurement. In this case you would type in
1.010” as the Pitch, and then press the SAVE
key.
14. Press the EXIT soft key 5 times to get back to the “Startup Screen”
15. Press the Advanced soft key.
16. The screen at the right will appear.
Select Sensor 1.
Select option to edit, or
Press RUN to tab using Job 2.
Current liner type is: Opaque
# Tabs Length Backing EXIT
Press Pitch to enter Tab pitch, or
Press Opaque or Clear for Backing type.
Current liner type is: Opaque
Opaque Clear Pitch EXIT
Enter tab pitch and press SAVE key.
0.0” Current Value: 1.010”
EXIT
Press RUN to tab using Job 2.
Status: Pieces: 0
Mode Tab Jog Pass-Thru Advanced
Press Pitch to enter Tab pitch, or
Press Opaque or Clear for Backing type.
Current liner type is: Opaque
Opaque Clear Pitch EXIT
Sensor 1 is currently: Enabled
Choose: Sensor 1, or Sensor 2 to enable
Status: Advanced
Sensor 1 Sensor 2 More… EXIT