Operation mod.2, Mod.1 – Partner PFT3540 B User Manual

Page 6

ENGLISH -

OPERATION

MOD.2

(Fig.F

-F

VII-

VIII

-F

)

Once the machine has been set up properly, start the

engine as follows:
Before starting work, it is necessary to carry out the

following:
- set the trasport wheels (5) upwards.
a)

Engines with choke system:

if the model is equipped with an accelerator, when

the engine is cold, position the accelerator lever (2)

on START
Engines with primer system:

Press the fuel-enrichment pump located on the car-

burettor 3 or 4 times.if the model is equipped with an

accelerator, position the accelerator lever (2) on MAX.

Grip the engine start grip (10) and pull the starter

rope gently until you feel the resistance caused by

compression. Release the handle; then give the starter

rope a sharp tug.

For further information and explanations, read careful-
ly the user instruction manual of the engine

WARNING! Never keep the two handles (12-13)

activated at the same time. It may cause damage

to the belts and pulleys

WHEN THE TILLER IS ON: in order to make the tiller

blades (6) run, handle (12) must be depressed. When

working with the tiller, keep the handle depressed.
If the handle is released, the tiller blades will come to

a stop.
Depress the skid in order to work in depth and decrease

the pressure to move forwards.
REVERSE-GEAR: for engaging the reverse-gear, only

handle (13) must be actuated.
How to stop the engine:

for this purpose, shift the accele-

rated lever into STOP position.
The four cutter stars (6) can be pulled off, and the combina-

tion of cutters allows working widths from 5 to 55 cms.
For assembly, introduce the blade star (6) to the rotary

shaft (N) and make the two holes (P) match: then introduce

pin (R) by fastening it with the respective spring. Make sure

that the hoeing blades are assembled in the right direction,

i.e. the cutting angle showing forward.

MOD.1

(Fig.F

-F

II-

III

-F

)

Once the machine has been set up properly, start the

engine as follows:
Before starting work, it is necessary to carry out the

following:
- set the trasport wheels (5) upwards.
a)

Engines with choke system:

if the model is equipped with an accelerator, when the

engine is cold, position the accelerator lever (2) on

START

Engines with primer system:

Press the fuel-enrichment pump located on the car-

burettor 3 or 4 times.if the model is equipped with an

accelerator, position the accelerator lever (2) on MAX.

b) Grip the engine start grip (10) and pull the starter

rope gently until you feel the resistance caused by

compression. Release the handle; then give the starter

rope a sharp tug.

For further information and explanations, read careful-
ly the user instruction manual of the engine.
Initially position the hook (15) of the forward drive cable

and the hook (16) of the reverse clutch cable in the holes

(II°) of the respective handles (1-13).
Should the handle action not follow the cutter clutch,

position the hook into hole (I°) of the handle, while on the

contrary insert it into hole (III°) should the cutters remain

engaged even on release of the handle itself.

WARNING!

Never keep the two handles (12-13)

activated at the same time. It may cause damage

to the belts and pulleys.

WHEN THE TILLER IS ON: in order to make the tiller bla-

des (6) run, handle (12) must be depressed. When working

with the tiller, keep the handle depressed. If the handle is

released, the tiller blades will come to a stop.

Depress the skid in order to work in depth and decrease