Orion System SA Controller - Manual (Page 8)

Zone
Zone
Interfaces Overview
SA Controller Operator Interface 8
Service Tool and System Manager Keys
The Modular Service Tool and System Manager allow you to view any
temperature or output condition and change any setpoint to fi ne-tune
the operations of the total system. All keypad operations are simple and
straightforward, utilizing non-cryptic plain English messages.
Display Screens & Data Entry Keys
The System Manager’s and Modular Service Tool’s display screens are
very similar. For most setpoints and modes, there are only a few dif-
ference in the function of the keypads. In this manual, when there are
differences in the keypad input or the screens between the two operator’s
interfaces, both screens or keypads will be shown. See the chart below
for a list of the keypad descriptions and functions.
Keypad
Description
Key Function
System Manager Modular Service Tool
ESC
Use this key to exit from
screens or from data entry
or to return to the Main
Menu from any screen in
the system.
Same function as
System Manager
ENTER
Use this key to close
a data entry fi eld and
advance to the next item
or screen.
Same function as
System Manager
Clear
If a data entry mistake is
made, press this key to
clear the data entry fi eld
and start over.
Same function as System
Manager but also turns
off the power to the
Service Tool when on the
Main Menu Screen
Minus
If a setpoint with a
negative value is required,
press this key for the
minus sign.
Same function as
System Manager
DEC
Press this key when
entering data that requires
a decimal point.
Same function as
System Manager
  Use these keys to step to
the next controller on the
loop on interconnected or
networked systems.
Same function as
System Manager

 Use these keys to step
backward or forward
through the screens.
Same function as
System Manager
Operator Interfaces Comparison
In order to confi gure and program the Orion System controllers, you
must have an Operator’s Interface or a personal computer with the Prism
II computer front-end software installed. Two different Operator Inter-
faces are available for programming of the Orion Controls System—the
Modular Service Tool and/or the Modular System Manager. These
devices allow you to access the status and setpoints of any controller on
your communications loop. This manual describes the Modular Service
Tool and Modular System Manager.
Mode
Selection
ENTER
CLEAR ESC
PREV NEXT
DOWN
UP
6 5 4
DEC
7
0
8
1 3 2
9
MINUS
-
STATUS
SETPOINTS
SCHEDULES
CONFIGURATION
ALARMS
ON
OVERRIDES
BALANCE - TEST
ENTER
CLEAR ESC
PREV NEXT
DOWN
UP
6 5 4
DEC
7
0
8
1 3 2
9
MINUS
-
STATUS
SETPOINTS
SCHEDULES
ALARMS
OVERRIDES
System Manager
Modular Service Tool
Modular System Manager