MovinCool Climate Pro 18 Service Manual - Manual (Page 42)

Operation Section
42
6. EXTERNAL DEVICE CONNECTION
6.1 Millivolt Thermostat Connection (Optional Accessory)
WARNING
Disconnect power before installation. Beware that some residual voltage may remain in
the unit immediately after the power is disconnected.
1) Select the proper location where the millivolt thermostat can be conveniently accessed and
install it at the selected location.
CAUTION
Do not install the millivolt thermostat where artificial heating condition may occur (i.e. hot stove,
hot pipe, and fireplace or under direct sunlight).
2) Set the millivolt thermostat to cool or heat mode without power connection on the unit. Prepare
the millivolt thermostat wires.
Recommended wire size:
- 18 ~ 20 AWG
3) Turn the unit off and unplug the power cord.
Take out seven (7) screws and remove the
service panel from rear of the unit.
4) Squeeze the inner latches and push out the
black cap from inside the panel. Insert the
millivolt thermostat wires through the hole in
the rear panel.
Screws (7)
Cap
ILL00806-00
ILL00046-01
Latch
Cap