Dialogic DSI SS7MD - Manual (Page 157)

157
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
7.10 MAP Configuration Commands
The MAP configuration commands are:
•
MAP_CONFIG - Configure MAP
•
MAP_TRACE - MAP Trace
7.10.1 MAP_CONFIG – Configure MAP
Synopsis
The MAP_CONFIG command provides the MAP operating parameters and, if used, must appear after the
SCCP_SSR commands in the config.txt file. The use of this command is not required and MAP is configured
with default values if the MAP_CONFIG command is not present.
Syntax
MAP_CONFIG
Example
MAP_CONFIG 2
Parameters
The MAP_CONFIG command includes the following parameters:
•
Specifies MAP protocol options as defined for the MAP Configuration Request message in the MAP
Programmer’s Manual.
7.10.2 MAP_TRACE – MAP Trace
Synopsis
The MAP_TRACE command is used to configure MAP to send trace messages to the trace module whenever a
specific message type is sent or received. See the MAP Programmer’s Manual for details.
Syntax
MAP_TRACE
Example
MAP_TRACE 0xf 0xf 0x4
Parameters
The MAP_TRACE command includes the following parameters:
•
Output event trace mask.
•
Input event trace mask.
•
Non-primitive trace mask.