Dialogic DSI SS7MD - Manual (Page 131)

131
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
7.3.2 MTP_LINKSET – Configure a Linkset
Synopsis
Configuration of a linkset to an adjacent signaling point.
Syntax
MTP_LINKSET
Example
MTP_LINKSET 0 321 2 0x0000 456 0x8
Parameters
The MTP_LINKSET command includes the following parameters:
•
The logical identity of the linkset, in the range 0 to one less than the number of linksets supported. The
linkset_id is used in other commands for reference.
•
The point code of the adjacent signaling point.
•
The number of links to be allocated to the linkset.
•
A 16-bit value reserved for future use to specify runtime options. Currently, no options are defined,
therefore the parameter must be set to 0.
•
The point code of the signaling point itself.
•
The value to be used in the Sub-Service Field (SSF) of all MTP3 messages and checked for by the
discrimination function in all received messages. This is a 4-bit value. For ANSI operation, each of the
two least significant bits should be set to 1.
Note: For correct operation, the adjacent point code must also appear in an MTP_ROUTE declaration.
7.3.3 MTP_LINK – Configure a Link
Synopsis
Supports configuration of either MTP or ATM signaling links. The command is differentiated based on the data
rate parameter. If an ATM link is specified, multiple MTP_LINK commands may reference the same ATM cell
stream provided the cell stream VPI-VCI combination is unique.
The syntax for either form of the command is shown below