5 mtp_user_part, Mtp_user_part, Configure a local user part – Dialogic DSI SS7MD User Manual
Page 135
135
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
— All other bits are reserved for future use and must be set to 0.
7.3.5
MTP_USER_PART – Configure a Local User Part
Synopsis
Configuration of a local user part module, other than a user part which has its own configuration command in
the config.txt protocol configuration file.
Syntax
MTP_USER_PART
Example
MTP_USER_PART 0x0a 0x2d
Parameters
The MTP_USER_PART command includes the following parameters:
•
The service indicator.
•
The module id of the user process.
Note: This command must not be used when the corresponding configuration commands are used
(
, etc.) since these commands automatically perform the function of
the MTP_USER_PART command.