Ivoclar Vivadent IPS e.max Press Abutment Solutions v.2 - Manual (Page 53)

53
General
Information
–
Material
Selection
Table
| Pr
ess
and
Firing
Parameters
Select the press program in accordance with the selected ingot to be pressed
and the investment ring size used.
Programat EP 3000
Select the press program in accordance with the selected ingot to be pressed
and the investment ring size used.
Programat EP 5000
The press parameters for HO, MO, LT and HT are integrated starting
with software V 6.1.
The press parameters for HO, MO, LT and HT are integrated starting
with software V 6.1.
Press and Firing Parameters
Press parameters for IPS e.max Press
The press furnace, investment ring size and the selected IPS e.max Press ingot must be considered:
B t➚ T H V
1
V
2
°C °C/min °C min °C °C
700 60 925 15 500 925 Program 11-20
Software 2.9
700 60 930 25 500 930 Program 11-20
Software 2.9
700 60 920 15 500 920 Program 11-20
Software 2.9
700 60 925 25 500 925 Program 11-20
Software 2.9
Press furnace IPS e.max Press
ingots
IPS Investment
Ring System
100 g
200 g
100 g
200 g
EP 500
HO, MO, LT
HT
B t➚ T H A
°C °C/min °C min
700 60 915 15 300 µm/min
700 60 920 25 300 µm/min
700 60 910 15 300 µm/min
700 60 915 25 300 µm/min
Press furnace IPS e.max Press
ingots
IPS Investment
Ring System
100 g
200 g
100 g
200 g
EP 600
Combi HO, MO, LT
HT
– The firing parameters listed represent standard values and apply to the Ivoclar Vivadent furnaces P300, P500, P700,
EP 3000 and EP 5000. The temperatures indicated also apply to furnaces of older generations. However, the temperature
in the firing chamber may deviate by approx. ± 10 °C/18 °F, depending on the age of the heating muffle.
– If a non-Ivoclar Vivadent furnace is used, temperature corrections may be necessary.
– Regional differences in the power supply or the operation of several electronic devices by means of the same circuit
may also render adjustments of the temperatures necessary.