Ivoclar Vivadent IPS e.max Press Abutment Solutions v.2 - Manual (Page 37)

37
Application
procedure
–
Permanent
Cementation
e.max
®
Press
Abutment Solutions
Permanent Cementation
IPS
Careful preparation of the bonding surface is a prerequisite for an optimum adhesive cementation of the
Ti base and the pressed object. The following paragraphs outline the required procedures. The procedure is
the same for hybrid abutments and hybrid abutment crowns.
IPS e.max Press Abutment Solutions
Abutment,
abutment crown
Ti base
Blasting –
The bonding area with Al
2
O
3
at low pressure
Etching
The bonding area with
IPS ® Ceramic Etching Gel for 20 s
–
Conditioning/silanating
The bonding area
with Monobond ® Plus for 60 s
Adhesive cementation Multilink ® Implant MO 0
Covering the cementation joint Glycerine gel, e.g. Liquid Strip
Curing
7-minute curing
(optionally in a light-curing device)
Polishing the cementation joint Customary polishers for ceramic/resin materials
All the materials that are required for permanent cementation
and for clinical try-in are contained both in the IPS e.max Press
Abutment Solutions Basic Kit A–D* and the IPS e.max
Abutment Solutions Cem Kit*.
* The range of available products may vary from country to country.