Ivoclar Vivadent IPS e.max Press Abutment Solutions v.2 - Manual (Page 28)

28
Firing­parameters­for­the­Glaze­firing­
IPS­e.max­Ceram­on­IPS­e.max­Press
Abutment Solutions
B
°C
S
min
t
°C/min
T
°C
H
min
V
1 ­
°C
V
2 ­
°C
L
°C
Glaze firing 403 6:00 60 770
1:00–
2:00
450 769 500
If­the­gloss­is­unsatisfactory­after­the­first­Glaze­firing,­further­Glaze­firing­procedures­may­be­conducted­
using­the­same­firing­parameters.
Note:­
If­the­layer­thickness­is­less­than­2­mm­on­the­entire­pressed­object,­long-term­cooling­(L)­is­not­required­to­
produce­a­tension-free­condition.
Completely glazed and characterized abutment and abutment crown
Adjustments­with­IPS­e.max­Ceram­Add-On
Use IPS e.max Ceram Add-On Dentin and/or Incisal to make adjustments to the abutment or
abutment crown after Glaze firing. Please observe the following procedure for processing:
– Mix IPS e.max Ceram Add-On Dentin or Incisal with IPS e.max Ceram Build-Up Liquid soft or
allround and apply on the corresponding areas.
– Fire with the stipulated parameters for the "Add-On after Glaze firing". Observe long-term cooling!
If necessary, polish the adjusted areas to a high gloss after firing.
Firing­parameters­IPS­e.max­Ceram­Add-On­after­Glaze­firing.
IPS­e.max­Ceram­on­IPS­e.max­Press B
°C
S
min.
t
°C/min
T
°C
H
min
V
1 ­
°C
V
2 ­
°C
L
°C
Glaze firing 403 6:00 50 700 01:00 450 699 500