Harken 7413.10 MKIV Jib Reefing & Furling built after Feb. 2009 - Manual (Page 8)

Preassembly Toggle Deductions/Stay Into Foil Options
8 MKIV units 3, 4
Use dimensions of Harken toggle below to build stay to correct length.
Tip: Turnbuckles should be 1/2 to 2/3 rds open to allow shortening for new wire stretch and for fine-tuning mast rake.
1. Swage stud at end of wire.
2. Open end of wire and install Norseman or STA-LOK ® stud after foil is assembled.
3. Rod adapter nosepiece for Harken rod adapter stud: Threaded nosepiece must
have a positive lock as well as adhesive. Use Harken stud with cotter pins.
See page 22.
WARNING! Using a threaded nosepiece with only adhesive at the
upper rod eye terminal may result in headstay system failure.
Make sure there is a mechanical lock.
Unit Clevis pin Ø Pin-to-pin length
3
19.1 mm ( 3 /
4
") 83 mm (3 9 / 32 ")
22.2 mm ( 7 /
8
") 98 mm (3 7/8 ")
Options for Feeding Stay into Foils
Unit Clevis pin Ø Pin-to-pin length
3
19.1 mm ( 3 /
4
") 83 mm (3 9 / 32 ")
22.2 mm ( 7 /
8
") 98 mm (3 7 / 8 ")
4
19.1 mm ( 7 /
8
") 98 mm (3 7 / 8 ")
25.4 mm (1") 115 mm (4 9 / 16 ")
28.57 mm (1 1 / 8 ") 127 mm (5")
STA-LOK is a registered trademark of Barfield Engineering Company Ltd.