Harken 7413.10 MKIV Jib Reefing & Furling built after Feb. 2009 User Manual
Page 18
18
MKIV units 3, 4
Hold plastic wedge in place with thumb
as you insert into foil. Line foil holes
with connector screw holes.
Assembly Foils/Connectors
Tip: In cooler weather, keep sealed adhesive in
pocket to keep it warm. Use instructions below to
fill injector less than half way; you will only use
a small amount of adhesive. Refill if needed
but do not keep open sealant for long periods.
Use adhesive within three (3) hours.
Use cap of adhesive to break seal. Remove injector
tip cap and plunger. Hold injector at an angle with
applicator tip facing down. Squeeze adhesive into
tube so lower half of injector is full as shown. Keep
tip free of sealant to let air inside.
Loading Injector with Adhesive
Adhesive in
lower half
Start plunger into injector and immediately hold
upright so plunger is down and applicator tip is up.
As sealant runs down toward plunger, an air
pocket will form near tip. Push plunger to evacuate
air. You are now ready to begin injecting adhesive.