Grandstream GVR3550 User Manual - Manual (Page 92)

Grandstream Networks, Inc. GVR3550 User Manual Page 92 of 120
Firmware Version 1.0.0.65 Last Updated: 10/2014
Table 33: GVR3550 HDD S.M.A.R.T Detection Parameter Explanation:
Parameter Explanation
Continue Using HDD
when Self-test Failed Continue to use the HDD if self-test failed in the process of S.M.A.R.T. detection..
HDD Number HDD Number 1 - 4 will be allocated in sequence after HDD mounted,
The number will not be changed in the subsequence use
Detection Type Set S.M.A.R.T. Detection type. There are three types: Short, Long, Conveyance
Start Click the button to initiate S.M.A.R.T. Detection
HDD Temperature Display the HDD temperature S.M.A.R.T Detection detected.
Usage Time Display the total usage time of HDD S.M.A.R.T Detection detected
Detection Status S.M.A.R.T detection Result: Pass or Fail
Evaluation Result S.M.A.R.T detection evaluation result: Good or Bad
Overall Evaluation Display the overall HDD status after detection
The HDD bad sector could be detected via Bad Sector Detection as shown in Figure 77 below.
Figure 77: GVR3550 HDD Bad Sector Detection Page