Grandstream GVR3550 User Manual - Manual (Page 30)

Grandstream Networks, Inc. GVR3550 User Manual Page 30 of 120
Firmware Version 1.0.0.65 Last Updated: 10/2014
LOCAL OPERATIONS
In this chapter, we take using the mouse as an example.
USING THE WIZARD
Users could use the wizard for basic configuration once started the GVR3550 to make it work properly.
1. Enter administrator password (The default is "Admin") to log in the GVR. Check to confirm whether to
enable the wizard next time boot up the unit.
2. Click on "Next" to access basic settings page to configure language and display time. Set time zone
and system time.
3. Click on "Next" to access network settings page to set up IP address, subnet mask and gateway.
4. Click on "Next" to access HDD management page to set up HDD array and HDD full strategy.
5. Click on "OK" to finish setup.
LOGIN
Input the username and password to login or click on the menu button in the lower left corner of the
page to login. The factory default username is "admin", the password is "admin". Users have to login
again if timeout without operations. Password change recommended after initial login.
After logging in the GVR3550 local page, users could click right mouse and then select any item in a pop-
up menu to bring up the GVR3550 login page.