Grandstream GXP2200 User Manual - Manual (Page 145)

Firmware Version 1.0.3.26 GXP2200 USER MANUAL Page 144 of 159
 None. Call forwarding feature is disabled. This is the default setting;
 Unconditional. Forward all calls to particular number;
 Time based. Set a time range. In the time range, calls are forwarded to the number specified in In
Time Forward To; out the time range, calls are forwarded to the number specified in Out Time
Forward To;
 Others. When phone is busy, calls are forwarded to the number specified in Busy To; when
incoming calls are not answered, those calls are forwarded to the number specified in No Answer
To; the waiting time for answering calls is specified in No Answer Timeout (s).
NETWORK
Users can configure Ethernet, Wi-Fi Bluetooth, VPN, PPPoE and other advanced settings under Network.

Ethernet. Check/uncheck to turn on/off Ethernet so that users can connect to LAN networks;

Ethernet Settings. Configure Ethernet Devices, Address Type (DHCP or Static IP). If Static IP is used,
enter the information for IP Address, Subnet Mask, Default Gateway, DNS Server and Alternative DNS
server;

Wi-Fi. Check/uncheck to turn on/off Wi-Fi so that users can connect to Wi-Fi networks;

Wi-Fi Settings. Check/uncheck to turn on/off Wi-Fi, Network notification. Select the scanned SSID in
the detected list or Add Wi-Fi network. Then enter the correct password to connect using Wi-Fi;

Bluetooth. Check/uncheck to turn on/off Bluetooth so that you can connect with other Bluetooth
devices;

Bluetooth settings. Check/uncheck to turn on/off BlueTooth. Set up Device name, Discoverable,
Discoverable timeout, Scan for devices;

VPN settings. Add VPN using different protocols (PPTP, L2TP, L2TP/IPSec PSK, L2TP/IPSec CRT).
Once selected, set up the VPN name, VPN server, Encryption information and DNS search domains;

PPPoE. Check/uncheck to turn on/off PPPoE. Enter PPPoE Account ID and PPPoE Password to
connect;

Additional Networks Settings.
 Layer 3 QoS for SIP. This field defines the layer 3 QoS parameter for SIP packets. It is the value
used for IP Precedence, Diff-Serv or MPLS. The Default value is 48;
 Layer 3 QoS for Audio. This field defines the layer 3 QoS parameter for audio packets. It is the
value used for IP Precedence, Diff-Serv or MPLS. The Default value is 48;
 Layer 2 QoS 802.1Q/VLAN Tag. This field contains the value used for layer 2 VLAN tagging. The
Default value is 0;
 Layer 2 QoS 802.1P/Priority Value. This assigns the priority value of the Layer2 QoS packets.
The Default value is 0;
 802.1x mode. This option allows the user to enable/disable 802.1x mode on the phone. The
default setting is disabled. To enable 802.1x mode, this field should be set to EAP-MD5. Once