beautypg.com

Advanced settings/general settings – Grandstream GXP2200 User Manual User Manual

Page 129

background image



Firmware Version 1.0.3.26 GXP2200 USER MANUAL Page 128 of 159

the selected ring.

Upload Local MOH Audio File

Click on "Browse" button to upload the music file from local PC. The

MOH audio file has to be in .wav or .mp3 format.

Note:

Please be patient while the audio file is being uploaded. It could take

more than 3 minutes to finish the uploading especially the file size is

large. The button will show as "Processing" during the uploading. Once

done, it will show as "Browse" again. Click on "Save" on the bottom of

the web page and "Apply" on the top of the web page to save the

change.

Enable Local MOH

If set to "Yes", local MOH will be turned on. Users will need upload a

local MOH audio file so it can be played on the other party when the user

puts the other party on hold. The default setting is "No".

ADVANCED SETTINGS PAGE DEFINATIONS

ADVANCED SETTINGS/GENERAL SETTINGS

Local RTP Port

Defines the local RTP-RTCP port pair used to listen and transmit. It is

the base RTP port for channel 0. When configured, for audio, channel 0

will use this port_value for RTP and the port_value+1 for its RTCP;

channel 1 will use port_value+4 for RTP and port_value+5 for its RTCP.

For video, channel 0 will use port_value+2 for RTP and port_value+3 for

its RTCP; channel 1 will use port_value+6 for RTP and port_value+7 for

RTCP. The default value is 5004.

Use Random Port

When set to "Yes", this parameter will force random generation of both

the local SIP and RTP ports. This is usually necessary when multiple

phones are behind the same full cone NAT. The default setting is "Yes"

(This parameter must be set to "No" for Direct IP Calling to work).

Disable in-call DTMF display

When it's set to "Yes", the DTMF digits entered during the call will not

display. The default setting is "No".

Keep-alive Interval (s)

Specifies how often the phone sends a blank UDP packet to the SIP

server in order to keep the "ping hole" on the NAT router to open. The

default setting is 20 seconds.

STUN Server

The IP address or Domain name of the STUN server. STUN resolution

results are displayed in the STATUS page of the Web GUI. Only

non-symmetric NAT routers work with STUN.