beautypg.com

Maintenance/syslog – Grandstream GXP2200 User Manual User Manual

Page 137

background image



Firmware Version 1.0.3.26 GXP2200 USER MANUAL Page 136 of 159

Config File Prefix

Enables your ITSP to lock configuration updates. If configured, only the

configuration file with the matching encrypted prefix will be downloaded

and flashed into the phone.

Config File Postfix

Enables your ITSP to lock configuration updates. If configured, only the

configuration file with the matching encrypted postfix will be downloaded

and flashed into the phone.

mDNS Override Server

Allows mDNS override config/firmware server setting on the phone if

present. The default setting is "Yes".

DHCP Option 66 Override

Server

If DHCP option 66 is enabled on the LAN side, the TFTP server can be

redirected. The default setting is "Yes".

DHCP Option 120 Override SIP

Server

Enables DHCP Option 120 from local server to override the SIP Server

on the phone. The default setting is "Yes".

3CX Auto Provision

Enables automatic provision feature on the phone when 3CX is used as

the SIP server. The default setting is "Yes".

Automatic Upgrade

Enables automatic upgrade and provisioning. The default setting is "No".

Automatic Upgrade Check

Interval (m)

Specifies the time period to check for firmware upgrade (in minutes).

The default setting is 10080 minutes (7 days).

Hour of the Day (0-23)

Defines the hour of the day to check the HTTP/TFTP server for firmware

upgrades or configuration files changes.

Day of the Week (0-6)

Defines the day of the week to check the HTTP/TFTP server for

firmware upgrades or configuration files changes.

Automatic Upgrade Rule

Defines the rules for automatic upgrade: Always Check at bootup, when

F/W pre/suffix changes, Skip the Firmware Check.

Auto Reboot to Upgrade

Without Prompt

If set to "Yes", the phone will automatically start upgrading after

downloading the firmware files. Otherwise, users would need confirm in

the prompted message in LCD to start upgrading process. The default

value is "Yes".

Authenticate Conf File

Authenticates configuration file before acceptance. The default setting is

"No".

Factory Reset

Restore to factory default settings.

MAINTENANCE/SYSLOG

Syslog Server

The URL/IP address for the syslog server.

Syslog Level

Selects the level of logging for syslog. The default setting is "None".

There are 4 levels: DEBUG, INFO, WARNING AND ERROR. Syslog

messages are sent based on the following events: