Gasboy FHO Pods - Manual (Page 12)

10 FHO Pods User’s Manual
S b e W M O C t r o F – . 7 - 1 e r u g i F ite – Ethernet Setup Screen
8. Enter the new IP Address
9. Click on the Submit button to save the changes
10. Select the Save Setup tab. The following screen appears (see
8 - 1 e r u g i F )
Figure 1-8.– FortCOM Web Site – Save Setup Screen
11. Click on Apply to apply the changes
12. The website displays a confirmation message. Click OK. The data is saved into the Flash
memory chip
13. Once the Flash memory has successfully stored the setup and configuration data, a pop-up
message requires restarting the system. This procedure is recommended. Click OK
14. Set newly changed IP address in FHO (refer to paragraph 6 . 1 )
N N O O T T E E
It is highly recommended to replace the existing IP
Address label with a new label indicating the current
IP Address
.