Gasboy Tag Reader - Manual (Page 8)

Tag Reader Installation Guide 4
0
SECTION 1
GE
SECTION 1
GE NERAL DESCRIPTION NERAL DESCRIPTION
1-1. 1-1.
SCOPE SCOPE
This manual is provided to assist you in installing the Gilbarco TR- Tag Reader . The Tag Reader
must be installed as described in this manual to ensure unit reliability and normal operation.
This manual includes a general and functional description of the Tag Reader. It provides the
installation requirements and procedures for the Tag Reader.
This manual is intended for qualified authorized installers of the Tag Reader. It is also intended for
the Island electrician.
1-2. 1-2.
DESCRIPTION DESCRIPTION
1-2.1. General
The Gilbarco Tag Reader (P/Ns: Tag Reader - PA04020000, Tag and Magnetic Card Reader -
PA04020001) is a standalone reader unit for contactless cards and tags intended for vehicle or
driver tag identification in gas stations and other applications. In addition, it can also be equipped
with an optional magnetic card reader, at the right-hand side of the unit. The TR includes a
Security Application Module (SAM) used to handle encrypted contactless cards and tags. The TRis
within easy reach of the customer wishing to refuel, and transmits the information to the station
automation system (CFN PLUS) over an RS-485 shielded cable.
The TR is designed to be installed in a non hazardous location in the station.
1-2.2. Description
The Tag Reader has a modern, stylish-look, with a clean panel, which includes two indicators
(green and red) and a large LCD. Its operation is very simple: to start a fuel purchase, the customer
waves the tag or card in front of the unit. After the tag is recognized and validated, clear messages
shown on the display guide the customer and help him to complete the transaction. In addition to
the LCD, an internal buzzer beeps to provide audio feedback and the status of the current operation
is indicated by the green and red indicators.
One or several TRs can be installed in a single station for improved service. In this case, all TRs in
the station should be connected to the same single CFN PLUS (e.g. Fuel Truck Controller or others)
via RS-485.connection.