Gasboy Tag Reader - Manual (Page 21)

Tag Reader Installation Guide 17
6. Install the Tag Reader with support flange to the installation site: Smooth flat surface/Pole/
Dedicated Pole/CFN PLUS (with special flange)
7. Secure the Tag Reader support flange at installation location using the appropriate screws,
spring washers and flat washers. Make sure the rubber seal remains properly seated under
the Tag Reader base.
8. In case of installation to the CFN PLUS, attach a special flange to CFN PLUS lower plate
with two appropriate screws
9. Proceed with the wiring connections (paragraph 2-5.4).
Figure 2-4. Tag Reader Installation Holes and Grommet Cap, Rear View
2-5.4. 2-5.4.
Wiring Wiring
The Tag Reader is equipped with a single cable carrying the Power and Serial Communication
cable. The Tag Reader requires power input and data input/output connections. The RS-485 wires
should be connected to the appropriate CFN PLUS serial communication ports. The cables must be
inserted through dedicated conduits that comply with UL/EU regulations and any other local
regulations. The cables enter the CFN PLUS from the sealing glands that ensure the box sealing.
Proceed as follows: